Trade Agreement: WTO-AGP/NAFTA/AIT/Canada-Peru
FTA/Canada-Colombia FTA
Tendering Procedures:
Attachment: None
Competitive Procurement Strategy: Lowest/Lower Bid
Comprehensive Land Claim Agreement: No
Nature of Requirements:
NISO - AIRCRAFT PAINT & PRODUCTS
T8493-120008/B
Gray, Jane
Telephone No. (819) 956-0109
Fax No. (819) 997-0437
E-mail. j••••••••@••••••••.••.ca
Transport Canada, Aircraft Services Directorate has a
requirement for the supply of aircraft paint and products on an
as and when requested basis during the period of April 1, 2012
to
March 31, 2015 with a possibility of a two year extension.
The Aircraft Services Directorate of Transport Canada is an
approved Air Operator and an approved maintenance organization.
Their fleet consists of fourteen MBB 105 helicopters, five Bell
212 helicopters, three Bell 407 helicopters, ten Bell 206
helicopters, nine Citation II aircraft, one DHC-7 Dash seven,
two DHC-8 Dash eight, six Challengers, and twelve King Air C-90A
aircraft.
LIST OF MANDATORY REQUIREMENTS
M1 - The Offeror must comply with the terms and conditions of
this solicitation;
(A statement of compliance for each RFSO numbered clause is
required. It is the responsibility of the offeror to identify
and address any exception(s). The offeror must clearly
demonstrate that the exception(s) will be fully covered by
another deliverable, otherwise the offeror will be considered
as non-compliant. Preference will be given to offeror's
requesting a minimum of exceptions. If you comply to a clause,
please express your compliance with few words such as "Read,
understood and agreed". Expand only when there is an
exception. Keep it simple.)
M2- The offeror's proposal must be valid for 60 days from
closing date.
M3 - The offeror must provide the following certification:
("We hereby certify that the price quoted is not in excess of
the lowest price charged anyone else, including our most
favoured customer for like quantity and quality of the
product").
M4 - Offeror's must identify key technical problems, if any,
and outline solutions for each call-up.
(Identification of problems and justification of solutions is
the responsibility of the contractor).
M5 - The offeror must be able to supply paint systems that meet
Boeing specifications BMS 10-60 Type I & II C1B, Gr D, and
BMS 10-72 Type X, and provide certificates of conformity
stating that the product delivered meets Boeing minimum
product specifications standards.
M6 - The contractor must maintain a maximum turnaround time of
45 calendar days commencing from the date of receipt of the
order.
Delivery Date: Above-mentioned
The Crown retains the right to negotiate with suppliers on any
procurement.
Documents may be submitted in either official language of Canada.
