Trade Agreement: NAFTA/AIT/Canada-Peru FTA/Canada-Colombia FTA
Tendering Procedures:
Attachment: None
Competitive Procurement Strategy: Lowest/Lower Bid
Comprehensive Land Claim Agreement: No
Nature of Requirements:
RUDDER PINTLE AND BUSH MATERIALS
F2599-120346/A
Tamaro, Daniel
Telephone No. - (819) 956-5319 ( )
Fax No. - (819) 956-0897
RUDDER PINTLE AND BUSHING MATERIAL FOR CCGS GRIFFON
The Canadian Coast Guard intends to renew the rudder pintles, of
the CCGS Griffon at a later date. The Contractor will provide
rough material stock for three rudder pintles, three rudder
pintles nuts, and three rudder pintel bronze bushings. All
material inspected, approved and stamped with identification
marks by a Marine Classification Society, approved by Transport
Canada Marine Safety.
Rough material stock required:
a. Marine Classification Society material approved and stamped
for rudder pintle and nuts as follows: forged 410 Stainless
Steel material normalized and tempered for the rudder pintles
and nuts.
· One piece of round stock 43 inches long by 12 inches in
diameter;
· One piece of round stock 81 inches long by 8.5 inches in
diameter.
b. Marine Classification Society material approved and stamped
material for rudder pintel bronze bushings rough cut material
Bronze C93200 / SAE 660 continuous cast for the three bushings
for pintles. The rough cut size is the same for the upper,
middle and lower bushings:
· One piece 34 inches long by 13.5 inches O/D with 7 inches I/D.
The requirement is subject to the Agreement on Internal Trade
(AIT) and the North American Free Trade Agreement (NAFTA).
Firm Delivery Date: On or before March 29, 2013
Delivery Date: Above-mentioned
The Crown retains the right to negotiate with suppliers on any
procurement.
Documents may be submitted in either official language of Canada.
