(OCIN) Transports Canada réparation,révision, modification, moteur ROLLS ROYCE 250

Trade Agreement: WTO-AGP/NAFTA/AIT/Canada-Peru
FTA/Canada-Colombia FTA
Tendering Procedures: All interested suppliers may submit a bid
Attachment: None
Competitive Procurement Strategy: Lowest/Lower Bid
Comprehensive Land Claim Agreement: No
Nature of Requirements:
This amendment is raised to replace the Annex A and the closing
date.

R&O ROLLS ROYCE 250 SERIES

T8493-120044/A
Coté, Michel
Telephone No. - (819) 956-0118 ( )
Fax No. - (819) 997-0437

This Request for a Standing Offer (RFSO) is for a National
Individual Standing Offer (NISO) for Transport Canada to
provide repair, overhaul, modification, exchange and/or
replacement of rolls royce 250 series engines, module parts,
components and accessories on an as and when requested basis for
the department of Transport Canada, during the period November
1st, 2012 to October 30, 2015 with the possibility of a 1 year
extension.

Mandatory Requirements

M1 - The Offeror must comply with the terms and conditions of
this solicitation; (A statement of compliance for each RFSO
numbered clause is required. It is the responsibility of the
offeror to identify and address any exception(s). The offeror
must clearly demonstrate that the exception(s) will be fully
covered by another deliverable, otherwise the offeror will be
considered as non-compliant. Preference will be given to
offeror's requesting a minimum of exceptions. If you comply to a
clause, please express your compliance with few words such as
"Read, understood and agreed". Expand only when there is an
exception. Keep it simple.)

M2- The offerors proposal must be valid for 60 days from closing
date

M3 - The offeror must be a Transport Canada or an FAA Approved
Parts Distributor for communication, navigation, and/or
autoflight instruments and/or equipment and provide the
certification showing this approval. Airworthiness certification
must accompany each unit as laid out by the Canadian Aviation
Regulations (CARs).

M4 - The offeror must provide the following certification:
("We hereby certify that the price quoted is not in excess of
the lowest price charged anyone else, including our most
favoured customer for like quantity and quality of the product").

M5 - The offeror must sell/provide only parts that are specified
in the call up that have been produced by the Original Equipment
Manufacturer (OEM), or the original parts manufacturer. Parts
Manufacturer Authority shall not be used without prior approval.

M6 - Offerors must identify key technical problems, if any, and
outline solutions for each call up. (Identification of problems
and justification of solutions is the responsibility of the
contractor).

M7 - The offerors proposal must be valid for 60 days from
closing date
Delivery Date: Above-mentioned

The Crown retains the right to negotiate with suppliers on any
procurement.

Documents may be submitted in either official language of Canada.