Trade Agreement: NONE
Tendering Procedures: All interested suppliers may submit a bid
Competitive Procurement Strategy: Lowest/Lower Bid
Comprehensive Land Claim Agreement: No
Nature of Requirements:
EZ899-181493/A
Leung, Janie (PWY)
Telephone No. - (778) 919-3273
Fax No. - (604) 775-6633
Email: J••••••••@•••••.••.ca
Title:
Osoyoos UPS Replacement
Location:
Osoyoos Port of Entry, Osoyoos, BC
Work Description:
The Work comprises of the replacement of existing UPS, breaker, conduit, wiring at Osoyoos border crossing, Osoyoos, BC. The Work to be performed under this Contract includes, but is not limited to:
.1 Replace existing true online UPS with new as to manufacturer requirements. New UPS to be 20kVA true online. Manufacturer must have a factory trained service representative within Canada and within 400kM of site. Existing unit being replaced is a Liebert model # 20KVA, S3. Replacement unit must meet or exceed power output and quality of the existing unit.
.2 Replace line side breaker as per manufacturer’s specification to match existing distribution board. Note: the existing breaker and wiring is under sized. Existing distribution board is a Cutler Hammer PRL 1A.
.3 Replace line side wiring with new and to be splice free according to manufacturer’s recommendations. Minimum to be copper wiring #4 AWG, 3 phase, 4 wire, with 600 volt, R90, XLPE insulation c/w green ground wire.
.4 Co-ordination and temporary power connection for users will be required for the power isolation time to replace the existing breaker and wiring for the replacement UPS system.
.5 Remove existing UPS and batteries from site diverting for recycling. Provide disposal documentation.
.6 Provide seismic design and install seismic restraints as per design.
.7 Include monitoring card for future. Existing unit is not monitored at this time.
.8 Provide temporary power for the UPS loads affected by power isolation. Keep power isolation to existing loads to less than 15 Minutes. Wire from existing panel NL1. Existing distribution board is a Cutler Hammer PRL 1A.
.9 Pre-install wiring to make isolation time as short as possible.
Site Visit:
Contractors are strongly recommended to visit the site prior to submitting a tender for this work and to make inquiries or investigations necessary to become thoroughly acquainted with the site as well as the nature and extent of the work.
There is an optional site visit for prospective bidders on Thursday, December 14, 2017 at 10:00 am PST at the Osoyoos Port of Entry, Osoyoos, BC.
Delivery Date:
The Contractor shall perform and complete the Work within sixty (60) days of Contract award.
Enquiries:
Janie Leung, Supply Specialist
Tel: (778) 919-3273
Fax: (604) 775-6633
Email: J••••••••@•••••.••.ca
Value of Project:
To assist with insurance requirements, this project is estimated to cost between $35,000.00 to $45,000.00
Firms intending to submit tenders on this project should obtain tender (solicitation) documents through Buyandsell.gc.ca/tenders. Addenda, when issued will be available from Buyandsell.gc.ca/tenders. Firms that elect to base their bids on tender (solicitation) documents obtained from other sources do so at their own risk and will be solely responsible to inform the tender calling authority of their intention to bid.
This procurement office provides procurement
Delivery Date: Above-mentioned
The Crown retains the right to negotiate with suppliers on any procurement.
Documents may be submitted in either official language of Canada.
